Command input from MDI does not respond.

Post Reply
aldoo
Posts: 5
Joined: Sat Feb 09, 2019 6:23 pm

Command input from MDI does not respond.

Post by aldoo » Sat Feb 09, 2019 7:05 pm

When I try to move the X axis from the MDI with G1X100 the axis does not move, but when I move the axis with the jog in the software then the axis does move, then I try to move the axis from the MD again and then the axis is move
1. Why does this happen?
2. What can I do to always respond to the commands I entered from the MDI?
3. I have tried with the G28 and G28.1 commands but these commands does not respond.
4. When I try to move my axes to zero machine does not respond, it seems as if the software is frozen and I have to try several times to make it work.

mycnc
Posts: 403
Joined: Thu May 10, 2018 2:42 pm

Re: Command input from MDI does not respond.

Post by mycnc » Sun Feb 10, 2019 12:57 am

An answer in a video, please check it.

youtu.be/YILlc2APiMg

Post Reply