ET10 Board for Raspberry Pi4

ivan
Posts: 273
Joined: Tue Apr 16, 2019 5:30 pm
Location: Ottawa, Canada

Re: ET10 Board for Raspberry Pi4

Post by ivan »

As for the screenshots, I'd recommend resizing them (using GIMP or a similar program).

Alternatively, you can upload them onto some third-party hosting platform (such as Dropbox, Imgur, etc) and then link them here.

Bharat Autotech
Posts: 10
Joined: Thu Jan 30, 2020 3:13 pm

Re: ET10 Board for Raspberry Pi4

Post by Bharat Autotech »

Hello Ivan,
I was able to read dxf files,also able to import dxf files from USB.Please look at image attached confirm these steps are correct or not!
Secondly,I was trying to find parameter of 'Kerf Compensation',its actually cutting tool compensation required to be put according to size of cutting tips(electrode,nozzles for Plasma or Cutting tips for Oxy-fuel)given in charts!
Regards,
Shailesh Gaikwad
Owner Bharat Automation Technologies
WhatsApp Image 2020-02-21 at 13.00.44.jpeg
WhatsApp Image 2020-02-21 at 13.04.09.jpeg
WhatsApp Image 2020-02-21 at 13.05.03.jpeg

mycnc
Posts: 712
Joined: Thu May 10, 2018 2:42 pm
Location: Ottawa, Canada
Contact:

Re: ET10 Board for Raspberry Pi4

Post by mycnc »

It's better to set

Code: Select all

/media/pi
in NC code folder, you will be able to load files from any USB disk inserted, not only labelled "SNF".

"Tool radius compensation" supported in G-code, but not in DXF import currently.

Post Reply