XHC WHB04B-6 Pendant

Post Reply
pSimon
Posts: 13
Joined: Fri May 11, 2018 7:51 am

XHC WHB04B-6 Pendant

Post by pSimon » Wed May 16, 2018 2:45 pm

I notice you support the XHC pendant units - does support include the LCD on the pendant as well as the buttons?

mycnc
Posts: 140
Joined: Thu May 10, 2018 2:42 pm

Re: XHC WHB04B-6 Pendant

Post by mycnc » Wed May 16, 2018 7:53 pm

We have PHB04B-6 and PHB02B pendants with LCD.
Yes, LCD is supported.
phb04B.jpg
phb04B.jpg (245.25 KiB) Viewed 406 times
It's possible to print ASCII symbols unlike previous XHC models.
At the moment we have fixed screen for XHC, but plan to add custom screen configuration later.

We haven't tested WHB04B model yet. According to the manufacturer, it should be compatible with PHB04B. However, WHB is a cheaper model for "hobbyists" and has 3 lines display only.

pSimon
Posts: 13
Joined: Fri May 11, 2018 7:51 am

Re: XHC WHB04B-6 Pendant

Post by pSimon » Thu May 17, 2018 7:39 am

Thanks.

Post Reply